How to Repair Kemper™ & JD® Rotary Corn Head Intake Disc Sections | Kooima Ag
Kooima Ag
•
3m 5s
KK90654 RH Section: https://www.kooimaag.com/products/intake-disc-weld-on-section-clockwise-rotation-right
KK90655 LH Section: https://www.kooimaag.com/products/intake-disc-weld-on-section-counterclockwise-rotation-left
KK4500CB Adjusting Bar Tool: https://www.kooimaag.com/products/kooima-adjusting-bar
Up Next in Kooima Ag
-
K502STOP Installation on a 497 Series...
When you are grinding ear corn, it can be a challenge to keep the feed rolls open wide enough to feed properly. On Claas® 497, 498, 499 & 502 series machines, the upper feed rolls are controlled by hydraulic cylinders to monitor the crop flow. When doing ear corn the cylinders are too tight even ...
-
K502STOP Installation on a 502, 499, ...
On Claas® 497, 498, 499 & 502 series machines, the upper feed rolls are controlled by hydraulic cylinders to monitor the crop flow. When doing ear corn, the cylinders are too tight, even on the lowest setting. The cylinder pulls the ear corn down and does not allow it to reach the cutter drum. Ou...
-
K494STOP Earlage Kit Installation, Cl...
Our new K494STOP Kit is just what you need when it comes to grinding ear corn with a 494 series Claas® forage harvester. This kit will help raise the feed rolls, allowing more room to feed in the earlage. To install, the process is straightforward and can be switched back just as easily. See the ...
