K502STOP Installation on a 502, 499, & 498 | Kooima Ag
Kooima Ag
•
5m 30s
On Claas® 497, 498, 499 & 502 series machines, the upper feed rolls are controlled by hydraulic cylinders to monitor the crop flow. When doing ear corn, the cylinders are too tight, even on the lowest setting. The cylinder pulls the ear corn down and does not allow it to reach the cutter drum. Our remedy for this was to give the upper rear feed roll a new bottom stop. This goes right on the cylinder, making it stay open to allow room for the ear corn. This is a must when grinding ear corn.
https://www.kooimaag.com/products/upper-rear-feed-roll-stop-497--502-series
Up Next in Kooima Ag
-
K494STOP Earlage Kit Installation, Cl...
Our new K494STOP Kit is just what you need when it comes to grinding ear corn with a 494 series Claas® forage harvester. This kit will help raise the feed rolls, allowing more room to feed in the earlage. To install, the process is straightforward and can be switched back just as easily. See the ...
-
Domai Direct Cut Head - Customer Test...
We have 25-foot heads available for John Deere®, Claas®, and New Holland®. Check them out on our equipment page here: https://www.kooimaag.com/equipment
-
Dual Roll Earlage Adapter for New Hol...
This adapter features an advanced crop flow system with an additional bottom intake roller, complementing the standard top roller. Specially engineered for higher horsepower harvesters and larger corn heads, the KFR920 delivers better cleanout, constant feeding, and increased harvesting speeds av...
